Shenzhen Everbest Machinery Industry Co. Ltd

Model Number: TH101-03-16 Brand Name: eoutil Key Specifications/Special Features: Key Specifications/Special Features:TH101 High Quality Electronic 3 In 1 Digital LCD Display Stud DetectorBattery InstallationSlide off the battery compartment cover on the back of the unit and insert one DC 9Valkaline battery (not included). Replace the compartment cover and securely snap in placeOperating Instructions

Metal/Voltage Detection
Hold the unit and turn the blue knob fully clockwise.
Make sure the unit is away from any metal or current-carrying conductor. Switch the Selector Switch to the VOLTAGE/METAL DETECTOR position. The green “ON” LED will light up immediately.
Turn the blue knob anti-clockwise until the indicators come on (red LED lights and BUZZER sounds). Reverse the blue knob gently until the indicators just go out.
Make sure the unit is working properly prior to use by placing the detector near to a metal object or known live power cable (e.g. table lamp cable or extension lead.) See point (6) if no detection is made.
Hold the detector and move it across the wall. When a metal object is detected, a continuous buzzer tone will sound.Current-carrying conductor will be shown with a red blinking LED and beeping sound of BUZZER
After the set has been switched on, an adjustment has to be made if the detector does not appear to work. Please refer to “UNIT ADJUSTMENT” section in the instructions.

Stud Detection
Hold the unit vertically as shown in Fig. 5 and turn the blue knob fully clockwise.
Switch the Selector Switch to STUD DETECTOR position.
Turn the blue knob anti-clockwise until the indicators come on (green LED and red LED successively light, and BUZZER sounds).
Reverse the blue knob gently until red LED just goes out and BUZZER ceases.
It will need to be adjusted if the unit cannot be set accordingly. For details, please refer to “UNIT ADJUSTMENT”.
Make sure the detection face marked “STUD” is placed against the wall when moving the unit horizontally across the wall (see Fig. 6). If the incorrect face is used, the green LED will go out and you will need to commence calibration from step (1) again.
Mark the position on the wall when an edge of a batten or wall stud is under the groove of the unit, the red LED will come on and the BUZZER will sound (see Fig. 7).
Resume the movement of the unit. When the green LED comes on and the BUZZER stops, mark this position also. These marks indicate the edges of the batten or wall stud. The middle point between two marks will be the centre of the batten or wall stud.